BIGTREETECH - ADXL 345 Accelerometer Board For 36 Stepper Motors
BIGTREETECH - ADXL 345 Accelerometer Board For 36 Stepper Motors
The ADXL345 V1.0 is a three-axis accelerometer board produced by the 3D printing team of Shenzhen Biqu Technology Co., Ltd. 36 stepper motor extruders. It can be connected to the motherboard using a 6Pin ZH1.5 connector. More
Manufacturer: BIGTREETECHProduct code: 57751 Shipping and Payment
The ADXL345 V1.0 is a three-axis accelerometer board produced by the 3D printing team of Shenzhen Biqu Technology Co., Ltd. 36 stepper motor extruders. It can be connected to the motherboard using a 6Pin ZH1.5 connector. More
Manufacturer: BIGTREETECHProduct code: 57751 Shipping and Payment
Functions
1. One end of the ADXL345 V1.0 cable uses a ZH1.5 6Pin plug and the other end uses a 2.54mm 6*1pin DuPont 70cm head, which can be easily compatible with motherboards without an ADXL345 connector. The cable is 70cm long, which is convenient for users to DIY.
2. It can be installed directly on the 36 step motor, which is suitable for permanent installation.
3. It can be directly connected to the 5V main board power supply using SPI communication.
4. The ADXL345 is a 3-axis accelerometer with a selectable measurement range of ±2g, ±4g, ±8g or ±16g, 13-bit resolution. The ability to measure both dynamic accelerations due to motion or impact, as well as stationary accelerations such as gravitational acceleration, allows the device to function as a tilt sensor.
Links
https://www.klipper3d.org/Measuring_Resonances.html
The cabling in the link is directly connected to the Raspberry Pi.
Important
1. The three-axis accelerometer ADXL345BCCZ must have a stable installation plane, otherwise it will affect the measurement accuracy.
2. Note that the board is powered by 5V. 5V and GND must not be connected backwards!
