IPA for cleaning equipment and building boards of 3D printers, Isopropyl alcohol 99.9% 1 l

IPA (Isopropyl Alcohol) is often used as a cleaner in 3D printing. It can be used to clean the print surface, remove adhesive residue and other contaminants from the print model. IPA also helps remove oils and grease from the print material, which can help improve print quality and reduce the risk of bubbles.

In addition, IPA is often used as a solvent to dilute printing coatings such as acrylic-based coatings and help improve their properties such as adhesion and transparency.

It is important to note that IPA is a strong solvent and can damage some materials such as plastic and rubber parts of the printer, so it must be used with caution and follow safety instructions.

It doesn't belong in the hands of Children!

Isopropanol is used to clean glass (with risk to anti-glare finish), remove odours and stains from leather surfaces. It does not degrade plastics.

Preparation of the skin cleanser: mix 1 part isopropanol with 4 parts water. Before use, test on a small portion of the surface to be cleaned to verify the colour fastness of the material.
Keep in the dark. Squeeze out the excess air if the packaging allows it.

WARNING:
H225: Highly flammable liquid and vapour
H319: Causes severe eye irritation
H336: May cause drowsiness or dizziness

EUH019 May form explosive peroxides.

S7: Keep packaging tightly closed
S16: Keep away from sources of ignition - No smoking
S24: Avoid contact with skin
S25: Avoid contact with eyes
S26: In case of eye contact, rinse immediately with water and seek medical attention