TH Board Set V9 (Dual Red Laser) - X1 Series

Overview
A set of printed circuit boards installed on the printer head.

Important information
You can check the version of your X1 TH series board on the Wiki page here:
https://wiki.bambulab.com/en/x1/manual/micro-lidar-model

There is no difference in functionality between the dual red laser version and the single red laser version.

The TH board with one red laser has been discontinued and replaced by the TH board with two red lasers.

The dual red laser TH board works with the dual red laser LIDAR.

If your Single Red Laser TH board is defective and needs to be replaced under warranty, we will provide you with a replacement TH + Dual Red Laser LIDAR board free of charge under warranty.

Installation
Before ordering a TH board or microlaser for the X1C/X1, please find out their version to avoid the wrong version leading to compatibility issues.

If the SN of the microlidar starts with 00ExxB, it means the lidar is a dual red version and the TH board should also be a dual red version with an SN serial number starting with 003xxC, 003xxD or 003xxY.

If the SN of the microlidar starts at 00ExxA, it means that the lidar is a single red version and the TH board should also be a single red version with an SN serial number starting at 003xxA or 003xxB.

Compatibility
X1 and X1C (not for X1E)

In the box
- TH V9 board set (double red laser)*1
- TH Board FPC cable V9*1
- TH V9 extrusion board*1
- M1_6-4*4
- Adhesive*1